|
|
|
|
|
06-06-2013, 08:42 PM
|
#1 | ||
|
Regular Member
Join Date: Oct 2006
Posts: 119
|
Hey guys,
I had to replace the top window seal on my AU as the old one had become too hard and cracked. Bought a second hand one from the wreckers and pushed it into place (little shorter than I would have liked it to be). Was fine for approximately 3 weeks, but now when the wind hits it creating popping noises all the time, and re-pushing it down fixes it only temporarily. Should I use a silicone (heard that was bad) or something to 'glue' it into place? Any advice would be great. Cheers,
__________________
1993 ED Falcon 2.5" Full Exhaust System Lovells Low Springs all round 2002 AU XR6 Manual, current project 2004 BF Fairmont Stock - family car |
||
|
|
|
07-06-2013, 09:40 AM
|
#2 | ||
|
Au Falcon = Mr Reliable
Join Date: Sep 2009
Location: North West Slopes & Plains NSW
Posts: 4,076
|
As long as you dont use the silicon on bare metal it should be fine imo, a little spot of superglue could do it also.
cheers, Maka
__________________
Ford AU Series Magazine Scans Here - www.fordforums.com.au/photos/index.php?cat=2792 Proud owner of a optioned keeper S1 Tickford Falcon AU XR6 VCT - "it's actually a better-balanced car than the XR8, goes almost as hard and uses about two-thirds of the fuel" (Drive.com 2007) |
||
|
|
|
|
07-06-2013, 10:31 AM
|
#3 | ||
|
FF.Com.Au Hardcore
Join Date: Aug 2006
Location: Salamander Bay
Posts: 5,427
|
you can get the entire moulding replaced properly at a windscreen fitter for $50
__________________
[SIGPIC][/SIGPIC]
Everyone starts off with a bag full of luck and an empty bag of experience. The trick is to fill the experience bag before the luck bag is empty. "It is better to remain silent and be thought a fool than to speak out and remove all doubt." Start a new career as a bus driver Rides: FG2 XR6 stock at this stage but a very nice ride xc 4 DOOR X CHASER 5.8 UNDER RESTO |
||
|
|
|
Front window seal
Linear Mode
