|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
06-02-2008, 01:33 PM
|
#1 | ||
|
Starter Motor
Join Date: Feb 2008
Posts: 2
|
I own a 2005 Fiesta LX 3dr manual. When I bought the car, the front bumper had two holes drilled to fit the black and white slimline plate (by Ford). On the back, the number plate itself had been drilled through (by Ford) to fit the two holes of the Fiesta about 10cm apart..
My question is, how do I fit my new slimline black and white plates to the Fiesta without drilling through my number plate? I was advised by the RTA that it is illegal to drill through a number plate. How has everyone else attached their plates? Do you know if a bracket to fit these number plates, or know of an aftermarket solution? Any ideas? Chris Last edited by ChrisE; 06-02-2008 at 01:34 PM. Reason: mistake |
||
|
|
| Thread Tools | |
| Display Modes | |
|
|
Number plate attachment?
Threaded Mode