Heat resistant paint or coating?

[mike_nofx]

I have a bit of a query regarding what options to use to change the colour of a wood heater.

I have a Norseman wood heater in brown that is basically this exact one:


So its a thicker steel box, surrounded by a sheetmetal cover which is some kind of enamel or powdercoat. With a newly renovated room, brown no longer suits and it would be good to change it to black.

I think powdercoating would be the best option if it can stand up to the heat. Being that the sheetmetal is more of a cover with a bit of an airgap and not in direct contact with the fire itself, it just MAY be ok. I never actually tested surface temperatures though.

Also the Flue is brown which may be more of an issue.

The other option is a potbelly paint, but it seems like a messier option which wouldnt have as good a finish, and probably easier to scratch.

What can you recommend?

[GasoLane]

https://www.stovebright.com.au/paint-powder

[simon varley]

from a car forum - how about exhaust header paint?

[mike_nofx]

Thanks for the suggestion.

I forgot to mention, one concern I have with heatproof paints such as what you suggested is that to cure the paint it must react a certain temperature. For that product you mention it’s 600f or 350c. I’m partly concerned that the surfaces I wish to paint may never reach that temperature and so I assume will never fully cure.

I only wish now that before removing the wood heater that I tested all surface temperatures with a heat gun with the heater at full temperature. Then I could have determined if powdercoat is adaquate or if I needed heat paint.

[roKWiz]

Originally Posted by mike_nofx

I have a bit of a query regarding what options to use to change the colour of a wood heater.

I have a Norseman wood heater in brown that is basically this exact one:
image

So its a thicker steel box, surrounded by a sheetmetal cover which is some kind of enamel or powdercoat. With a newly renovated room, brown no longer suits and it would be good to change it to black.

I think powdercoating would be the best option if it can stand up to the heat. Being that the sheetmetal is more of a cover with a bit of an airgap and not in direct contact with the fire itself, it just MAY be ok. I never actually tested surface temperatures though.

Also the Flue is brown which may be more of an issue.

The other option is a potbelly paint, but it seems like a messier option which wouldnt have as good a finish, and probably easier to scratch.

What can you recommend?

mike_nofx This is my solution for a coating.