|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-05-2012, 02:18 PM
|
#1 | ||
|
Regular Member
Join Date: Dec 2011
Posts: 484
|
http://www.youtube.com/watch?v=63k7ocnO6Do
It seems to be coming from the join in the two panels, but the join isn't visible from under the bonnet... any one have any suggestions? another video, found a water drop. http://www.youtube.com/watch?v=xrNN-Sy5QxY |
||
|
|
|
08-05-2012, 01:30 PM
|
#2 | ||
|
Regular Member
Join Date: Dec 2011
Posts: 484
|
I believe this is happening..
the passenger side air vent, that ducts from the plenum chamber into the cabin passes through two layers of metal, the plenum chamber, and the firewall. it has a foam seal on a flange on the inside of the cabin, which is meant to seal to the firewall. it also has a "hood" in the plenum to stop water running into the vent. problem is, the hood catches and directs water back towards the firewall, where it then runs around the plastic duct, into the hole, and down between the two layers of metal (the firewall and plenum chamber) and into the cabin. it appears that to remove the duct and seal it properly, will require me to remove the entire dash board... I guess it is a 23 year old car, but it would have been nice if they could have used sealant to begin with, instead of a foam gasket thats basically non existent now. |
||
|
|
|
|
08-05-2012, 03:18 PM
|
#3 | ||
|
Regular Member
Join Date: Dec 2011
Posts: 484
|
pulled the dashboard out far enough to get the duct out, going to seal it with a stack of sealant, and hope it fixes it.
Now that the duct is out, I'm not entirely sure that was the issue... |
||
|
|
|
|
08-05-2012, 03:20 PM
|
#4 | ||
|
Regular Member
Join Date: Dec 2011
Posts: 484
|
|
||
|
|
|
Water water everywhere? Another leaking ford?
Linear Mode
