|
|
|
|
|
|
|||||||
| Drag Racing Discuss Drag Racing here be it dirt or tarmac. Sponsored by Sydney Dragway. |
 |
|
|
Thread Tools | Display Modes |
29-05-2009, 12:23 AM
|
#61 | ||
|
Solution Was Boost 4?, 6 & 8
Join Date: Dec 2004
Location: Melbourne
Posts: 23,624
  
|
Sadly 1 of 2 tyres went missing in transit and its ended up in Sydney in quarantine how bazaar...
before anyone offers up some 15x15 tyres, Rod wont run 2nd hand tyres, importing your own means you get fresh rubber not something that has been sitting around going hard.. Well next time..
__________________
[SIGPIC][/SIGPIC]
AUTOTECH TUNED EDELEBROCK CHARGED 2017 GT Mustang Plenty of RWKW |
||
|
|
|
29-05-2009, 10:38 AM
|
#62 | ||
|
FF.Com.Au Hardcore
Join Date: Dec 2004
Posts: 5,644
|
This has been going nearly as long as my XA !!
I look forward to seeing it in action .. make sure you let us know well in advance. |
||
|
|
|
|
30-05-2009, 11:27 PM
|
#63 | |||
Join Date: Dec 2004
Location: in a house
Posts: 292
|
Quote:
i dont think this has been as long as your coupe, from memory you were building your coupe before i got my Pursuit this has however been a very long & large re-built, it started out as an engine rebuild for the Monza & has finnished up being a complete nut & bolt rebuild of the Pontiac in hind sight i should of just ordered a new car from the US & it would of been done with by now we were hopeing to come out & have a skid at the AFF Drag Day but sometimes the best laid plans go astray how close is your car we will have to catch up regards rod
__________________
A word to the wise ain't necessary, it's the stupid ones who need the advice. |
|||
|
|
|
|
31-05-2009, 08:16 AM
|
#64 | ||
|
FF.Com.Au Hardcore
Join Date: Dec 2004
Posts: 5,644
|
I think my XA rebuild will be shown on the history channel if it goes on any longer. I have rebuilt the motor but not put the geardbox and clutch back in. Then there is the wiring .
I will have to swing down and say hello soon, it's been a while. |
||
|
|
|
|
08-06-2009, 06:25 AM
|
#65 | ||
|
Regular Member
Join Date: Nov 2008
Posts: 110
|
I love the sheetmetal look. This is mine. Its a Big Block Buick. The block is been cast as we speak in the US. The heads I have which for small ports flow 380 cfm @ .600".
Hopefully have it running by end of year. Royden
__________________
2008 Plated BFII F6 Typhoon proud to have it tuned by Autotech |
||
|
|
|
Linear Mode
