[QUOTE=EGOG6ET;6138112]
Quote:
Originally Posted by Nosmo
This is what I did. I installed a 2 post hoist into my shed. My two issues were ceiling height & slab thickness.
I went with a hoist which is designed for height restrictions and then added extra large base plates to take into account my reinforced slab thickness of around 120mm.
This is the hoist, it's designed to be moveable/relocatable however I fixed it in place and had new hydraulic lines made up to run across the roof truss to the motor located on a side wall rather than the trolley.
http://happ.com.au/hoist_and_lift/ha...ly-adjustable/
I used these base plates in combination with the hoist and dyna-bolted to slab.
http://happ.com.au/miscellaneous/large-baseplates/
I used chemset and 20mm threaded rod so not to put and extra pressure on the slab. |
I have EXACTLY the same set up...